Hose
A
Tubing
B
Coiled Air Hose
& Fittings
C
Transportation
D
Fittings
E
Tooling, Equipment
& Accessories
F
Parker Hannifin Corporation | Parflex
®
Division | Ravenna, Ohio | parker.com/pfd
For detailed ordering information, please consult price list or contact Parflex
®
Division.
General Technical
G
11
Measure and verify hose assembly
length.
Measure crimp diameter of each
fitting at top, middle and bottom
of shell. Take measurements
at a minimum of three places
around shell circumference.
Verify crimp diameter is within
tolerances.
(Reference Crimp Die Selection
on Crimpsource online at
www.parker.com/crimpsource)
Inspect insertion depth mark at
fitting ends. Insertion mark must
be visible but not exceed 1/8"
from end of crimped fitting shell.
Measure & Inspect
MiniKrimp
™
Fitting Assembly Procedures
Permanent Crimp Series 56 (cont.)
8
To Next Page
Loading...
