Parker Parflange 1025 - Motor Replacement

105
Motor access
See maintenance sheet A 10
Motor upgrade
Loosen the 4 motor fastening screws (A) .
Replace the motor and rewire.
Check for correct belt tension (sag of
less than 10 mm). Adjust the setting
with the screws (B) if necessary .
Work on electrical components
should only be carried out by
expert staff. The machine must
be disconnected from the
electrical supply before wor
k
takes place on electric
al
components.
Maintenance sheet
Number
Index
Parflange 1025
Page
FIP025GB004 01
1/1
Motor replacement A 40 - page 36
A 40
1H00
Rewire the motor power supply with/as
with the thermal contact cable
(see sheet A 10 ).