Re-stringing tips
It is best to re-string your guitar on a regular basis. Over time, strings lose their ability to properly hold their tuning. They also collect dirt, which negatively affects tone.
It is recommended to re-string your guitar at least 4 times a year. Parker PDF models ship with light gauge .009-.042 gauge strings, though the instrument can handle up
to .011- .052 gauge strings. Larger string gauges may require modifying the tuning machine string slots to accommodate the additional thickness.
Always re-string your guitar one string at a time. This will ensure that you do not disrupt the set-up of your instrument.
Changing to an alternate string gauge (or thickness) may require that the instrument be adjusted to compensate for the difference in string tension.
To re-string the guitar, loosen the locking nut on the tuning machine at the headstock. Pull the string out- you will be able to remove the string entirely from the bridge by
pulling outward. Feed the new string through the string hole in the back portion of the bridge, along the neck, through the appropriate nut slot and finally through the
string post on the tuning machine. Pull the string through so it is tight, but with a little give. Tighten down the locking portion, and begin turning the tuning machine to
bring the string to pitch. For better intonation, you will only need a few winds of the string on the tuning post. Excess string may be clipped off and disposed of.
Cleaning/Storage
Do not store your guitar in an excessively hot or cold location. They are best stored in a cool, dry space when not in use, preferably a guitar case or gig bag with a guitar
humidifier (available at your favorite local music store!). Excessive heat and cold will damage your instruments finish, and may cause excessive neck movement/warping.
Any standard guitar cleaning polish will work to clean fingerprints and dirt from your guitar. Guitar polish kits are readily available wherever musical instruments are
sold.
Parker PDF models use an ebony fret board- it is best to clean with water. Lemon oil mixed with beeswax will keep your fingerboard from drying out.
To prevent tarnished hardware, it is recommended to also clean your hardware with a damp washcloth. Make sure to wipe gently as to not scratch your hardware.
To Next Page
Loading...
Need help?
General
