A
Accessories • 11
Auxiliary connection – electrical ratings • 13
B
Before commissioning the drive, please
observe the following: • 8
C
Cable installation: • 10
Cautionary Markings • 7
Conditions of utilization • 9
Conditions of utilization for CE-conform
operation • 9
Conditions of utilization for UL certification of
PSD1-S • 11
Connector overview PSD1-S • 15
Control requirements • 11
Control Voltage 24 VDC PSD1-S • 18
D
Data of integrated dynamic brake unit • 13
Designated use • 4
Device assignment • 4
E
EC declaration of conformity PSD1-S • 14
Environmental requirements PSD1 • 18
Explanation of the safety instructions • 6
F
Frontansicht (PSD1-M) • 15
G
General hazards • 6
Grounding requirements • 10
I
In- / Output Ratings • 13
Installations- & Environmental Characteristics
PSD1-S • 11
Introduction • 4
M
Mains connection PSD1-S • 18
Mains filter for use in industrial areas • 9
Motor and feedback cable requirements • 10
Motors • 10
Mounting and dimensions • 17
Mounting and dimensions PSD1-S • 17
N
Notes on the use in domestiv environments •
11
P
Packaging, transport, storage • 5
Protective earth • 10
R
Responsibility • 8
S
Safety instructions • 6
Scope of delivery • 4
Size / Weight • 18
Special dangers • 7
T
Technical Data • 18
Tightening torque of the wiring terminals • 12
Type identification plate PSD1-S • 4
U
UL certification • 11
V
View from above (PSD1-S • 16
View from below (PSD1-S) • 16
W
Warranty conditions • 8
What is necessary and where to find it? • 3
Working safely / qualification • 6
To Next Page
Loading...
