Parker PSD1-S - Safety Instructions

Introduction
6 (20)
192-011004N5 DOC-0002-01-R014 14.08.17 09:41
2.6 Safety instructions
In this chapter you can read about:
• Explanation of the safety instructions ............................................................................. 6
• Working safely / qualification .......................................................................................... 6
• General hazards ............................................................................................................ 6
• Special dangers ............................................................................................................. 7
• Cautionary Markings ...................................................................................................... 7
• Responsibility ................................................................................................................. 8
2.6.1. Explanation of the safety instructions
Indicates a potential risk that may result in death or severe injury.
Indicates a potential medium risk with that may result in death or severe injury.
Indicates a potential low risk with that may result in minor or moderate injury.
Alerts you to situations that may damage this product or other products.
2.6.2. Working safely / qualification
This device may be operated only by qualified personnel.
Qualified personnel in the sense of these operating instructions consists of:
• Persons who, by virtue to their training, experience and instruction, and their
knowledge of pertinent norms, specifications, accident prevention regulations and
operational relationships, have been authorized by the officer responsible for the
safety of the system to perform the required task and in the process are capable
of recognizing potential hazards and avoiding them (definition of technical
personnel according to VDE105 or IEC364),
• who have a knowledge of first-aid techniques and the local emergency rescue
services,
• who have read and will observe the safety instructions,
• who have read and observe the manual or help (or the sections pertinent to the
work to be carried out).
This applies to all work relating to setting up, commissioning, configuring,
programming, modifying the conditions of utilization and operating modes, and to
maintenance work.
This manual and the help information must be available close to the device during
the performance of all tasks.
2.6.3. General hazards
General Hazards on Non-Compliance with the Safety Instructions
The device described in this manual is designed in accordance with the latest
technology and is safe in operation. Nevertheless, the device can entail certain
hazards if used improperly or for purposes other than those explicitly intended.
Electronic, moving and rotating components can
• constitute a hazard for body and life of the user, and
• cause material damage