192-011006N8 PSD1 Installation Guide
192-011006N8 2019-07 09.10.19 09:27 25 (109)
2.11 Before commissioning the drive, please observe the following:
• Read the safety instructions.
• Make sure that all local electrical regulations are adhered to.
• Inspect the device for any damages.
• Inspect the device within the drive and system for loose ends, blends, grinding- or
drilling chips, etc.
• Check all external power circuits of the system: Power supply, control, motor and
ground connections.
• Make sure no damages or injuries may occur by a rotating motor. Uncouple the
load from the motor shaft.
• Check the condition of the motor thermistor- and brake resistance connections.
Make sure that all external set speeds are zero.
• Make sure nobody works with another part of the system which may affect
switch-on.
• Make sure that switch-on does not negatively influence other devices.
• Verify if the motor connections are correctly wired.
• Ensure that the STO function is not activated.
To Next Page
Loading...
