EN | User Manual Transportation, installation and storage
12 K-MT 10-95/D3
Installing the dryer
Caution!
Always use the lifting lugs at the top of the tank to lift the dryer. Use a lifting
beam with a suitable spacing for this purpose. This will ensure the tanks can-
not come in contact with the upper pipe bridge and thus damage it.
Remove the packaging of the dryer.
Attach suitable lifting gear to the transport lugs of the vessels (see gure I).
Raise the dryer (see gure II) and remove the transportation pallet.
Place the dryer at its installation site.
I: Transport lugs on pressure vessel
II: Installing by crane
Anchoring the dryer
Use suitable attachment material to anchor the dryer to the oor.
In the case of vibrating oors: place the dryer on suitable vibration dampers.
To Next Page
Loading...
