EN | User Manual Technical product description
18 K-MT 10-95/D3
Nozzle kit
In the case that the operating pressure deviates from the standard design pressure (7bare)
it is possible that the amount of necessary regeneration air changes. This effect may have
a negative impact on the cost-effectiveness of the dryer. To prevent this, it is possible to
replace the built in regeneration air nozzle by a nozzle with a modi ed bore. This replacement
optimizes the regeneration air consumption and therefore restores the energy ef ciency of
the dryer. To receive more information on this conversion, please contact the manufacturer.
To Next Page
Loading...
