parks audio Puffin - Puffin Quick Start Guide; Connecting the Puffin; Puffin Controls Overview; Initial Power-Up Procedure

PuYn Quick Start
 Connect the music source, like a turntable or CD player, to the PuYn's input.
 Then connect the PuYn's output to your main stereo device, like an integrated
amp or acve speakers.
 The PuYn has three controls: the Standby buon, the Knob, and the Select
(arrow) buon. The Standby turns the PuYn on and oV. The Knob quickly rotates
through sengs. The Select buon chooses the funcon or seng.

With your main system volume adjusted low, turn on the PuYn (allow 4 to 5 sec-
onds aer inially plugging in the DC adapter). If using a turntable, you can start
playing music as the default gain seng is for typical vinyl usage.

If you are using a CD player or other line output music device, scroll to the 'Set?'
control on the PuYn and adjust to the 'CD' preset for the correct ampli®caon.
Otherwise you will have a very loud output, as the PuYn ampli®es an otherwise
already large audio signal.
 Always have your system's master volume control adjusted low when changing
the 'Gain' seng or loading presets on the PuYn to prevent loud surprises. The
Standby buon is also a great emergency mute buon in an unexpected "loud
music" event.
 Other than some care with gain changes, just have fun with the PuYn. ou can't
break anything and can always revert to a default preset with the 'Set?' funcon.
So feel free to experiment.