6
IE
Sound pressure level
(L
pA
) ....................... 85.1 dB, K
pA
= 5 dB
Sound power level
(L
WA
) ..................... 96.1 dB; K
WA
= 5 dB
Vibration (a
h
)
Handle ..........2.699 m/s
2
; K= 1.5 m/s
2
Auxiliary handle ..1.937 m/s
2
; K= 1.5 m/s
2
For use with smart batteries
(SmartPAPS204A1/SmartPAPS208A1)
Operating frequency/
Frequency band .....2400 - 2483.5MHz
Max. transmission power .......≤ 20 dBm
The specied total vibration value and the
stated noise emission value have been
measured according to a standardised test
method and can be used to compare one
power tool with another.
The specied total vibration value and the
stated specied noise emission value can
also be used for a provisional assessment of
the load.
Wear ear protection.
Warning: The vibration and noise
emissions may deviate from the spe-
cied values during actual use of the pow-
er tool, depending on how the power tool
is being used and, in particular, what kind
of material is being worked on.
Safety measures for the protection of the
operator are to be determined that are ba-
sed on an estimate of the actual vibration
load under the real operating conditions
(for this, all parts of the operating cycle
are to be taken into account, for example,
times in which the power tool is turned off,
and those during which it is turned on but
running without a load).
Charging time
The device is part of the (Parkside) X 20
V TEAM series and can be operated with
batteries of the (Parkside) X 20 V TEAM
series.
Batteries of the (Parkside) X 20 V TEAM
series may only be charged using chargers
of the (Parkside) X 20 V TEAM series.
We recommend that you operate this appli-
ance with the following batteries only:
PAP20B1, PAP20B3,
SmartPAPS204A1, SmartPAPS208A1
We recommend charging these batteries
with the following chargers:
PLG20A3, PLG 20 A4, PLG20C1,
PLG20C3, PDSLG20A1,
SmartPLGS2012A1
An up-to-date list of battery compatibility
can be found at: www.lidl.de/akku
To Next Page
Loading...
Need help?
General