16 GB
Do not modify the product under any
circumstance. Modifications may result in
serious injury.
All servicing and maintenance, other than
the items listed in this instruction manual,
should be performed by an authorised
service centre.
Only use spare parts and accessories
provided by the manufacturer. All other
repairs shall only be carried out by an
authorised service centre. Improper
maintenance, use of non-conforming
components and removal of safety devices
can lead to a hazardous situation, such as
death, life-threatening injuries and damage.
Check the volume application rate during
operation.
Vibration and noise
reduction
To reduce the impact of noise and vibration
emission, limit the time of operation, use
low-vibration and low-noise operating modes
and wear personal protective equipment.
Take the following points into account to
minimise the vibration and noise exposure risks:
Only use the product as intended by its
design and these instructions.
Ensure that the product is in good condition
and well maintained.
Keep tight grip on the handles/grip surface.
Maintain this product in accordance with
these instructions and keep it well lubricated
(where appropriate).
Plan your work schedule to spread any high
vibration tool use across a longer period
of time.
Behaviour in emergency
situations
Familiarise yourself with the use of this product
by means of this instruction manual. Memorise
the safety warnings and follow them to the
letter. This will help to prevent risks and hazards.
Always be alert when using this product,
so that you can recognise and handle risks
early. Fast intervention can prevent serious
injury and damage to property.
Switch the product off and remove the
battery pack if there are malfunctions.
Have the product checked by a qualified
professional and repaired, if necessary,
before you operate it again.
Keep instructions or label of the spray
materials available at all times in order
to inform the doctor about the chemical
concerned in an emergency.
In an emergency, follow the chemical
manufacturer’s instructions provided or on
the label.
Observe manufacturer’s safety data sheets.
Procedure after accidents: If you have come
into contact with the spray solution, switch
off the product by switching the power
button[] to . Release the product
immediately by lifting the lower end of the
tab on both sides of the shoulder strap[6]
(Fig.P).
Danger to health due to contact
with plant protection products! Plant
protection products may cause damage to
health by inhalation, ingestion or absorption
through the skin. If symptoms occur or
in case of doubt, seek medical advice.
Therefore, observe the following safety
instructions:
– Observe the safety instructions on the
labels of the plant protection products.
– Observe the specified max.
concentration.
– Certain liquids require protective
goggles, gloves or other protective
measures.
– Always request and observe a
safety data sheet from the chemical
manufacturer.
– Always empty the spray solution when
you are safe.
To Next Page
Loading...
Need help?
General