11 GB/IE
Reading off the battery status
The status or residual power is indicated as follows
in the battery-operated LED
2
whenever the appli-
ance is switched on:
RED / ORANGE / GREEN = maximum charge /
power
RED / ORANGE = medium-level charge / power
RED = weak charge – recharge battery
Changing tools
Your cordless drill / screwdriver has a fully automat-
ic spindle lock
.
Once the motor has come to a halt, the drive shaft
is automatically locked, so that the chuck
10
can
be opened simply by turning it
.
After you have inserted the required bit and fixed it
in place by turning the chuck
, you can immedi-
ately continue working. The spindle lock releases
itself automatically when the motor is started (by
operation of the ON / OFF switch
4
).
2 Gear Drive
Note: Move the gear selector switch
1
only after
the device has come to a standstill.
In the first gear (Gear selector switch
1
in Position: 1)
you achieve a speed of up to approx. 350 rpm and a
high torque. This setting is suitable for all screwing tasks.
In the second gear (Gear selector switch
1
in Position: 2)
It achieves a speed of up to approx. 1300 rpm, for
the carrying out of drilling tasks.
Torque control / drill step
You can use the torque control / drill step
9
to
adjust the torque. When the value of the torque
setting is reached, the clutch disengages the drive
connection to the chuck.
Select a low setting for small screws, soft work
material.
Select a high setting for large screws, hard
work materials and for the extraction of screws.
For drilling work, select the drill setting by putting
the torque control / drill setting into the
position.
For drilling tasks, also push the gear selector
switch
1
to the rear (Position: 2).
Preparing the tool for use
Changing the direction of
rotation / unlocking the device
Unlock the device and change the direction of rota-
tion by pressing the rotational direction switch
3
to
the right or to the left.
Switching ON / OFF
Switching on:
To start the appliance squeeze on the ON /
OFF switch
4
and then keep it pressed down.
The light
8
comes on with a slightly or fully
pressed ON / OFF switch
4
and illuminates
the working area in poor lighting conditions.
Switching off:
To stop the appliance, release the ON / OFF
switch
4
.
Changing the rotational speed:
The ON / OFF switch
4
has a variable speed
control. Light pressure on the ON / OFF switch
4
causes the device to operate at a low speed. In-
creasing the pressure increases the speed.
Activating the lock
Press the rotational direction switch
3
into the
middle position. The ON / OFF switch
4
is
now blocked.
Before first use / Preparing the tool for use
To Next Page
Loading...
