PAHE 20-Li A1
GB
│
CY
│
3 ■
Package contents
1 cordless pruner PAHE 20-Li A1
1 shoulder strap
1 blade guard
1 Blade
1 saw chain
100 ml organic chain oil
1 assembly tool
1 operating instructions
Technical data
Cordless pruner PAHE 20-Li A1
Rated voltage 20 V
(direct current)
Max. rotational speed 2500 min
-1
No-load speed max. 5 m/s
Weight (without battery, cutting tool
and strap) approx. 2.6 kg
Oil tank volume 65 cm
3
Cut length approx. 200 mm
Blade 8” Oregon 080NDEA318
Saw chain Oregon 91P033X
Use only the following battery to
operate the cordless tool PAP 20 A3*
Type LITHIUM ION
Rated voltage 20 V
(direct current)
Capacity 4000 mAh/80 Wh
Cells 10
Use only the following high-speed
battery charger to charge the cordless tool
PLG20A2*
INPUT
Rated voltage 230–240 V ∼, 50Hz
(alternating current)
Power consumption 85 W
Fuse (internal) 3.15 A
T3.15A
OUTPUT
Rated voltage 21.5 V (direct current)
Charging current 3.5 A
Charging time approx. 80 min
Protection class II /
(double shielded)
* BATTERY AND CHARGER NOT INCLUDED IN
DELIVERY
Noise and vibration data
Measured values for noise determined in accord-
ance with EN ISO 22868. The A-rated noise level
of the power tool is typically as follows:
Sound pressure level L
pA
= 88 dB (A)
Uncertainty K
pA
= 3 dB
Sound power level L
WA
= 106 dB (A)
Uncertainty K
WA
= 3 dB
Wear ear protection!
Vibration values (vector total of three directions)
determined in accordance with EN ISO 22867:
Vibration < 2.5 m/s
2
Uncertainty K = 1.5 m/s
2
WARNING!
► Depending on the use and the activities to
be performed, the sound pressure level must
be reduced to a level that does not adversely
affect the health of the operator. The sound
pressure level at the workplace may exceed
80 dB (A). In this case, sound insulation
measures are required for the operator (e.g.
wearing hearing protection).
► Also reduce the risk of vibration, e.g. the
risk of white-finger disease due to frequent
breaks in work where like rubbing their palms
together! Translated with www.DeepL.com/
Translator (free version)
NOTE
► The vibration level specified in these instruc-
tions has been measured according to a
standardized measurement procedure and
can be used for equipment comparison. The
vibration emission value given may also be
used for an initial assessment of exposure.