35
The LEDs of the charge level indicator
show how much charge remains in the
battery.
2. Charge the battery (6) when only the
red LED on the charge level indicator
(9) is illuminated.
Charging the battery
See also the charger instruction manual.
Notes
• If warm, allow the battery to cool be-
fore charging.
• Do not expose the battery to direct sun-
light for long periods and do not place
it on a radiator (max. 50°C).
Charging the battery
1. Remove the battery (6) from the
device.
2. Push the battery (6) into the charging
slot of the battery charger (24).
3. Connect the battery charger (24) to a
power outlet.
4. After charging, disconnect the battery
charger (24) from the mains.
5. Pull the battery (6) out of the battery
charger (24).
Control LEDs on the charger (24):
greenredMeaning
lights up—• Battery is fully
charged
• stand-by (No
battery inserted)
—lights upBattery is charging
—flashesBattery is over-
heated
flashesflashesBattery is defective
Operation
Working with the device
WARNING! Risk of injury! Pay atten-
tion to the following instructions.
• Do not cut damp or wet grass.
• Before starting the device, make sure
that the cutting unit is not in contact
with stones, debris or other foreign ob-
jects.
• Switch on the device before approach-
ing the grass to be cut.
• Avoid over-stressing the device while
working.
• Avoid any contact with fixed obstacles
(rocks, walls, picket fences, etc.). The
nylon line on the spool would wear out
quickly.
• Avoid using the device in bad weather,
especially if there is a danger of light-
ning!
• Do not try to lock the on/off switch in
place. It must switch off the motor after
releasing the switch.
Cutting grass
1. Cut grass by swivelling the device to the
right and left.
2. Cut slowly and keep the device tilted
forward by approx. 30° when cutting.
3. Cut long grass in layers from top to bot-
tom.
To Next Page
Loading...
