Parkside PBM 125 A1 - Troubleshooting

44
GB IE
Troubleshooting
Problem Possible cause Troubleshooting
Engine won’t
start
Not enough petrol in the petrol
tank
Fill petrol
Incorrect starting sequence
Observe the instructions for starting
the engine (see “Operation”)
Spark plug connector (
12)
not plugged in correctly, sooty
spark plug
Plug in the spark plug connector
Clean, set or replace spark plug (see
“Cleaning and Servicing”)
Carburettor set incorrectly
Have the carburettor reset by a speci-
alist workshop
Engine starts,
but the device
does not run at
full power
Dirty air lter (
11)
Replace the air lter (see “Cleaning
and Servicing”)
Carburettor set incorrectly
Have a specialist workshop reset the
carburettor
Engine sput-
ters, slows
down
Carburettor set incorrectly
Have a specialist workshop reset the
carburettor
Sooty spark plug ( 13)
Clean, set or replace spark plugs (see
“Cleaning and Servicing”)
Engine overhe-
ated
Ventilation holes (
8) plugged Clean the ventilation holes
Incorrect spark plug (
13) Replace the spark plug
Not enough engine oil in the
engine
Top up engine oil (see “Initial start-up”)
Engine giving
off smoke
Dirty air lter (
11)
Replace the air lter (see “Cleaning
and Servicing”)
Not enough engine oil in the
engine
Top up engine oil (see “Initial start-up”)
Output not
satisfactory or
engine is dif-
cult to operate
Grass too short or high
Change the cutting height
(see “Setting the cutting height”)
Blade blunt see „Replacing blades“
Blade blocked by grass, grass
collection box full, ejector
opening plugged
Remove grass (see “Cleaning and
Servicing”)
Blade not ro-
tating
Blade blocked by grass Remove grass
Blade not mounted correctly
Fit the blade correctly (see “Replacing
blades”)
Abnormal
sounds, clatte-
ring or vibra-
tions
Blade not mounted correctly
see „Replacing blades“
Blade damaged