To Next PageTo Next PageWhat to do if my Parkside PKGA 14.4 A1 Power Tool has low power?
If your Parkside Power Tool has low power, it could be due to several reasons. First, ensure that the tool is suitable for the workpiece. If not, insert a suitable tool. Also, check the speed setting and adjust it accordingly. Finally, low battery power can also cause this issue; in that case, charge the battery.
Why does my Parkside PKGA 14.4 A1 Power Tool tool wear down quickly?
If the tool of your Parkside Power Tool wears down quickly, it could be because the speed is too high. Try reducing the speed.
Why is my Parkside PKGA 14.4 A1 Power Tool not starting?
Your Parkside Power Tool might not be starting because the rechargeable battery is discharged. To solve this, charge the rechargeable battery as described in the charging process section.
What to do if my Parkside PKGA 14.4 A1 does not move?
If your Parkside Power Tool's tool doesn't move even when the motor is running, it might be because the appliance attachment or tool is not correctly mounted. Ensure that you fit the appliance attachment or tool correctly, as described in the Operation section.
How to fix a Parkside PKGA 14.4 A1 Power Tool that works with interruptions?
If your Parkside Power Tool works with interruptions, the issue might be due to an internal lose contact. It should be repaired by a Service Centre.
Why is my Parkside PKGA 14.4 A1 not starting even after changing the battery?
If your Parkside Power Tool doesn't start, even with a charged battery, the on/off switch might be broken. In this case, the tool should be repaired by a Service Centre.
Why is my Parkside PKGA 14.4 A1 Power Tool not starting after battery replacement?
If your Parkside Power Tool isn't starting, it could be because the rechargeable battery is not inserted correctly. Make sure to insert the rechargeable battery as described in the charging process section.
Why is my Parkside PKGA 14.4 A1 appliance power low?
If you are experiencing low power with your Parkside Power Tool, the speed might be set incorrectly. Try adjusting the speed to the appropriate level.
General| Voltage | 14.4 V |
|---|---|
| Battery Type | Li-Ion |
| Max Torque | 30 Nm |
| Chuck Size | 10 mm |
| No-load Speed | 0-1300 rpm |
