Parkside PLPRS 1.5 B3 - First use; Battery insertion;exchange

■ 6
│
GB
│
CY PLPRS 1.5 B3
First use
DANGER
During the commissioning of the appliance
personal injury and property damage
could occur!
► Packaging material should not be used as
a play thing. There is a risk of suffocation.
Items supplied and transport
inspection
This Laminate/Parquet Repair Set is supplied with
the following components as standard:
▯ Wax melter
▯ Cleaning scraper
▯ Scraper with planer function
▯ Scraper with curvature
▯ 11 x Hard wax sticks
▯ Sanding sponge
▯ Cleaning cloth
▯ 2 x Batteries 1.5 V Type AA/LR6/Mignon
▯ Storage case
▯ This operating manual
NOTICE
► Check the contents to ensure that everything
is available and for signs of visible damage.
► If the contents are not complete, or are dama-
ged due to defective packaging or through
transportation, contact the Service Hotline
(see chapter Service).
Disposal of the packaging
Dispose of the packaging in an
environmentally friendly manner.
Note the labelling on the packaging
and separate the packaging material
components for disposal if necessary. The packaging
material is labelled with abbreviations (a) and
numbers (b) with the following meanings:
1–7: Plastics, 20–22: Paper and cardboard,
80–98: Composites.
Battery insertion/exchange
This wax melter requires 2 x 1.5 V batteries,
type AA/LR6/Mignon, for operation.
♦ Open the battery compartment
on the
back of the wax melter
.
♦ Insert the batteries into the wax melter
as indicated in the battery compartment
(see fig. 1).
♦ Close the battery compartment
.