10 GB/IE/CY
General safety advice for electrical power tools / Preparing for use
d)
Fluids may leak out of rechargeable
battery units if they are misused. If
this happens, avoid contact with the
fluid. If contact occurs, flush the affect-
ed area with water. Seek additional
medical help if any of the fluid gets
into your eyes. Escaping battery fluid may
cause skin irritation or burns.
Safety advice relating
specifically to cordless
impact drill / drivers
Wear ear protection when
percussion drilling. Exposure
to noise can cause hearing loss.
Use the additional handle
10
that came
with the appliance. Losing control of the
machine can lead to injuries.
Hold the appliance by the insulated
handling surfaces when you are carry-
ing out work during which the insertion
tool might hit on hidden power supply
lines or the appliance’s own power
cable. Contact with a live electrical wire can
also make metal parts of the electrical tool live
and can lead to electric shock.
Before cleaning or maintaining the
charger or battery pack always pull
the plug out of the mains socket. This
precaution is intended to prevent you from unin-
tentionally starting the device.
Never charge the battery pack if the
ambient temperature is below 10 °C
or above 40 °C. In this way you will ensure
your battery has long working life.
The ventilation openings on the charg-
er must always be kept free. Otherwise
there is the danger of overheating.
Before you carry out any tasks on the
device, transport or store it, make sure
that the direction of rotation switch
5
is in the middle position (lock) to pre
vent
the device from starting up uninten-
tionally.
Original accessories /
attachments
Use only the accessories detailed in
the operating instructions. The use of
inserted tools or accessories other than those
recommended in the operating instructions
could lead to you suffering an injury.
Caution utility services!
WARNING!
Ensure that you do not strike
electrical cables, gas or water pipes when you
are working with an electrical power tool.
Check a wall using a suitable detector before
you drill or cut slots.
Preparing for use
Attaching the auxiliary handle
Screw the additional handle
10
onto the left-
hand or the right-hand side of your appliance
depending on the way you work.
Charging the battery pack
Note: A battery pack that has been unused for a
while or never been charged must be charged
before reuse or first use. The battery pack requires
about 3 - 5 cycles before it can reach its full charge.
Charging takes about 90 minutes.
WARNING!
Always pull the mains plug from
the mains socket before removing the battery pack
from the charger or inserting it into the charger. This
precaution is intended to prevent you from uninten-
tionally starting the device.
Push the coupler (see Fig. A) onto the recharge-
able battery pack
9
. Insert the mains plug
into the socket.
The red charge indicator LED
15
indicates that
the charging process has started. The red light
goes out as soon as the battery pack
9
is fully
charged.
To Next Page
Loading...
