Particle Measuring Systems LASAIR II 550L Operator's Manual


Multi-Drop Command Coding OverviewMulti-Drop Command Coding Overview
PagePage
F-3F-3
CDELAY secCDELAY sec
Response: “Response: “
RDELAY secRDELAY sec
””
This is a backward compatible command. DeThis is a backward compatible command. Delay is specified as start of firstlay is specified as start of first
sample to start of next sample. Sample volume sample to start of next sample. Sample volume or sample time must be setor sample time must be set
first for this command to first for this command to work properly. Tiwork properly. Times are approximate mes are approximate if sampleif sample
volume is set rather than sample time.volume is set rather than sample time.
Set continuous sampling on/off (1/0). If turned off, then number of Set continuous sampling on/off (1/0). If turned off, then number of samplessamples
is set to one. Use CNOS to set is set to one. Use CNOS to set number of samples.number of samples.
CDT yy mm dd hh mm ssCDT yy mm dd hh mm ss
Set date and time. Either two Set date and time. Either two digit or four digit year is ok.digit or four digit year is ok.
Response: “Response: “
RDTRDT
””
CESCES
End Sampling.End Sampling.
Response: “Response: “RES 1RES 1””(success) or(success) or““RES 0RES 0” (failure)” (failure)
CFQCFQ
Response: “Response: “
RPQ 1RPQ 1
””
oror
““
RPQ 0RPQ 0
””
Flush data queue--erase all data. Note: LASAIR Flush data queue--erase all data. Note: LASAIR II can un-erase data fromII can un-erase data from
this command if no samples are taken, and locations are not erased.this command if no samples are taken, and locations are not erased.
CID nameCID name
Response: “Response: “
RID nameRID name
””
Set sample ID (location) to given string. This command translates allSet sample ID (location) to given string. This command translates all
characters to upper case. The characters to upper case. The only legal characters in this command areonly legal characters in this command are
A-A-
Z, a-z, and 0-9Z, a-z, and 0-9
. Other characters which are legal for LASAIR . Other characters which are legal for LASAIR IIII
location names are not legal here.location names are not legal here.
CISDELAY secCISDELAY sec
Response: “Response: “RISDELAY secRISDELAY sec””
Set inter-sample delay in seconds. Delay is from end-to-start.Set inter-sample delay in seconds. Delay is from end-to-start.
CKB nCKB n
Response: “Response: “
RKB mRKB m
””
Lock/unlock the keyboard (1/0). If the keyboard is not locked, theLock/unlock the keyboard (1/0). If the keyboard is not locked, the
instrument can be stopped or controlled from front panel.instrument can be stopped or controlled from front panel.
CNOS nnnCNOS nnn
Response: “Response: “
RNOS mmmRNOS mmm
””
Set total number of samples. Setting to -1 cSet total number of samples. Setting to -1 causes continuous sampling.auses continuous sampling.
If the operation is successful,If the operation is successful,
nnnnnn
==
mmmmmm
..
CPDELAY secCPDELAY sec
Response: “Response: “
RPDELAY secRPDELAY sec
””
Set purge delay in seconds.Set purge delay in seconds.

Particle Measuring Systems LASAIR II 550L Specifications

General

Brand	Particle Measuring Systems
Model	LASAIR II 550L
Category	Measuring Instruments
Language	English