www.paselec-ebikes.com
1.8 TIRE INFLATION
---------------------------------------------------
1. before riding the bike inflate the tires to recommended pressure
pointed out on the tires side.
2. use a pump that is suitable for your bike nipple. There are two
main types of nipples: PRESTA valve and SCHRADER valve(pic.30).
3. before pumping bicycle inner tube tires with presta valve, loosen the
protection screw(pic.31), to make sure it is working short-term press.
After pumping bicycle-type tires with nipple PRESTA, tighten the set screw.
1.9 INSTALLATION OF THE PEDALS
---------------------------------------------------
1. before adjusting a bike install the bicycle pedals This will facilitate adjustment of derail- leurs
2. pay attention to the mark L-left pedal R-right pedal). (pic.7)
3. install the pedals according to the mark on the axel. Tightening torque is 30-35 Nm (pic.8)
Inobservant tightening force may lead to thread damage during installation or during operation.
7
Warning: the danger of damaging the stem-to-fork assembly and the
risk of injury to the rider that can result from overtightening the stem
bolt or other clamping device.
To Next Page
Loading...