SKU Number: 356-9327
Model Number:
LED Solar Wedge Motion Light
Mounting Screw x2
Plastic Anchor x2
Questions, problems, missing parts?
Please visit our website at www.ewccelite.com, or email us at
customer-service@ewccglobal.com.cn, or call us at 1-888-722-5089
Choose a location with maximum sun exposure during the the day to install your wall light.
Do not install the light near an existing outdoor light. The built-in sensor will prevent it from turning the solar lights on.
When using the light in autumn and winter, please note that due to fewer daylight hours, the batteries might not
charge fully. This may effect the amount of time the light will be on.
During cold months in winter, we recommend to remove the light to prevent damage to the unit due to frost and
freezing temperature.
1
TWO
two
BATTERY REPLACEMENT
Press the button switch to the OFF position. The switch is located on the back.
Open the battery housing cover by removing the screws.
Replace the battery with a new 3.7V 18650 2000mAh lithium solar rechargeable battery,
ensuring the correct polarity is observed.
R
Not enough charge.
Make sure unit is installed where it can
get maximum exposure for hours.
4
us
Outdoor
5 feet
To Next Page
Need help?
General
