EasyManua.ls Logo

PATROLLINE HPS 930 - Foreword; Operating the HPS 930; Managing Modality (Way 1 & Way 2); Neutral Time Operation

PATROLLINE HPS 930
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PAG.2 DI 12 - REV. 0 – HPS 930 ING
User Manual
Thank you for choosing one of our product
This HPS 930 alarm system can be installed for the
protection of motorcycle, scooter or moped
Foreword…
The HPS 930 is an alarm for scooters and motorcycles, it’s suitable for the vehicle with the original immobilizer system.
It’s a device completely automatic and it’s widely programmable to adapt to many different needs.
This innovative device doesn’t need the remote control, but it uses the original key for its operations.
Operating…
The alarm HPS 930 can be managed in two different ways:
- WAY 1: activation when you turn OFF the ignition key;
To avoid the automatic activation (for example: during the supply) it’s necessary, once the ignition key is turned off,
to turn ON and turn OFF again.
- WAY 2: when you turn the ignition key OFF, the alarm is not activated. To activate it, it’s necessary to turn the
ignition key ON and OFF again.
When the system is activated, during the neutral time, the shock sensor is at maximum sensibility, so it can feel all the
movements and extend the neutral time. With this method the user can make all the routine manoeuvres, for example,
parking the vehicle or place the object into the compartment (under the seat, in the little trunk, etc.); after 15 seconds
without any shocks, the device stops the neutral time, and it is ready to operate. However, the neutral time is limited
to 40 seconds maximum.
During the neutral time, the LED is fixed ON, and it signals with a little flash when it feels a shock and extends the
neutral time. When it’s activated the LED flash and the shock sensibility return to its set level.