Paula Deen kitchen electrics PDPC8 - Page 17

$21,M+.'&"11$()4'
17
Problem
Reason
Solution
It is difficult to close the
lid.
The sealing ring is out of
place.
The float valve is stuck in
the push rod.
Place the sealing circle
properly.
Push the rod in place.
It is difficult to open the
lid.
After releasing, the float
valve has not gone down.
Press the float valve
down.
Steam is leaking from the
lid.
The sealing ring is out of
place.
There is food residue on
the sealing ring.
There is an abrasion on
the sealing ring.
The cover is not properly
placed.
Install the sealing ring
properly.
Clean the sealing ring
after every use.
Replace the sealing ring.
Close the lid properly.
Steam is leaking from the
float valve.
There is food residue on
the sealing ring.
There is an abrasion on
the sealing ring or the
float valve.
Clean the sealing ring
after every use.
Replace the sealing ring
or float valve.
The float valve will not
rise.
The float valve cannot
align with the position of
the sealing.
There is not enough food
or liquid in the pot.
Steam is leaking from the
lid or the float valve.
Set the float valve to the
right position.
Place enough liquid or
food inside the pot.
Please see points above
about the lid or float valve
leaking.