PAX Eos 100H - Speed Control; Humidity Control

EN - 12
Operang
Speed Control
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Humidity Control
Eos is factory set to start at a humidity level of 88%. The start point can be adjusted in nine (9) levels
between 40% and 88%.
The humidity level is indicated by three LEDs, with each LED represenng every third level.
(3rd, 6th, and 9th levels, with each step changing the sensivity by 6%.)
When the set humidity level is reached, Eos switches to operang in forced exhaust mode only. When
the humidity level later drops below the set level, the unit connues to operate in forced mode for 20
minutes to stabilize the humidity level. Aer that, Eos returns to its normal heat exchange operaon..
Note: If the start point for forced exhaust mode is adjusted to a value lower than 88%, it can cause Eos to
operate solely in forced exhaust mode during the summer when relave humidity is high. To avoid this,
the start point should be adjusted to a higher level.
Control panel on the unit
Press to change the air ow.
Three selectable modes: 20, 40 or 60m³/h
Control panel on the unit
Press
to change humidity sensivity.
Nine levels: 40 – 88 %
Sengs
Remote Control
Select: Low Mid High
Low Mid High