Part No. 1101-7119-01 © 2014 PAX Water Technologies, Inc.
PAX Water Mixer (PWM100)
Installation/Operation Manual
5
3. PAX Water Mixer Specifications
4. Installation Tools and Test Equipment
1. Wire Stripper/Crimper
2. Diagonal Cutter, 6” (150 mm)
3. Multimeter (Fluke #179 or equivalent)
4. Current Clamp (Fluke #10005 or equivalent)
Power Supply Required 120 VAC, 60 Hz, GFCI-protected, 20 amp circuit
Customer Supplied Power Switch 3R fused, safety disconnect switch
Motor Type
115 VAC, 60 Hz, water-filled, water-lubricated, single phase motor,
NSF 61
RPM 3450
Nominal Power Draw 1.15 kVA (670 watts)
Footprint Diameter 10” (25.4 cm)
Height 30” (76.2 cm)
Weight 40 lbs (18.1 kg)
Material: Motor Housing 316 stainless steel
Material: Motor Seals Chlorine/chloramine-resistant NBR rubber
Material: Foot Chlorine/chloramine-resistant EPDM rubber
Wiring NSF 61 & UL-listed submersible pump cable 14 AWG XLPE
Maximum Motor Wire Length 100’ (30.4 m)
NOTE: Contact your PAX Representation if you have questions on maximum motor wire length.
To Next Page
Loading...