PAX S920 - PAX S920 Terminal Overview; Key Definitions; Screen and Keypad Layout

PAX S920 Quick Setup Guide
10
Select [Connect Timeout] and verify the default
value of [300] is displayed and press [ENTER].
Select [Receive Timeout] and verify the value of
[450] is displayed and press [ENTER].
Select the [right arrow] and then select [WiFi
Parameters]. SEARCHING…
Select the desired SSID.
Note
If the desired SSID is not displayed,
then select {Other].
[Select SSID] and verify the value is entered as
case sensitive and then press [ENTER].
Select [Security] and then select the security type
required.
Select [Password] and verify the password
displayed matches the access point. If not, input the
case sensitive password and then press [ENTER].
Select [DHCP Type] then select [Static].
Select [IP ADDRESS] and verify the value
displayed is the correct value. If not, input the IP
address value and press [ENTER].
Select [Subnet Mask] and enter the value and
press [ENTER].