MAIN FUSELAGE CONSTRUCTION
Locate formers FF1 and FF2 and
two 1/8 x 2 x 6 pieces of
plywood; these are the main
fuselage formers.
Join the formers together with
the plywood pieces on a flat
surface and make sure you have
a left and right.
Locate formers BH3, BH3A and
BH2, BH2A. Using epoxy or CA
laminate formers BH3 and
BH3A aligning the ½ holes. Glue
BH2A into position on BH2 as
shown.
the top and
glue into position.
)
rmers. As shown in the photo.
ther side of the
int shown here.
Press four 6-32 t-nuts into the
holes in BH2A from
Locate former BH6 and trial fit
into the slots in the center of the
BH3 assembly. IMPORTANT:
Make sure the doubler (BH3A
is on the opposite side of the
joint between the two main
fo
Glue a piece of ½ balsa triangle
stock in place between BH3 and
BH6 on the o
jo
11
To Next Page
Loading...