The fuselage sections should arrive at the nose equally.
e onto
ction using masking tape as
before.
e HF1 formers as
shown (Below Right).
e
rily hold the fuselage
sides tight to BH6.
Locate the two HF1 formers and secur
the top se
Insert former BH4 into position on top of
BH6 and just behind th
While you may go ahead at this time and
securely glue most of the joints it is VERY
IMPORTANT that the fuselage sides only
be tack glued to the former BH6 towards
the rear of this assembly. In a later step
when the rear section (booms) are fitted to
the front section you will need to spread the
sides apart just slightly to bring the fuselag
sections together. You may use clamps at
this time to tempora
From the 1” x 1” x 36” balsa Triangle stock,
cut four three inch sections and glue them
above and below the forward gear mount as
shown.
13
To Next Page
Loading...