Joining the two fuselage sections
As you can see, the joining of the two sections is very straightforward. The bend in the
back of the fuselage will require the use of masking tape as before to hold everything
tightly in place while checking for squareness and fit.
The keys to the fit of the two
sections are the tabs on the
former BH7 and the
corresponding slots and tabs on
the fuselage sides and BH6.
Carefully align the two sections
and ensure that the fit of all
joints are tight and proper.
Use a medium CA to begin
tacking all joints working a
little at a time until you have a
good fit.
15
To Next Page
Loading...