Overview of the Systems Installation
Needless to say the operation of all systems within the model (radio, engine, retracts and
so on) is of the highest importance. The success of your model depends on these systems
working properly. The manufacturers of these systems will include information
pertaining to their operation, if you have experience in these areas you will have no
problem, if not we strongly recommend that you seek assistance in the installation and
operation of these systems.
CONTROL THROWS
Set these throws for your first flight. After getting to known your model better, adjust to
suit your needs.
Ailerons
Full rate…………………………………………..…1/2 inch up and down
Dual Rate………………………………………..…..3/8 inch up and down
Flaps
First Position (measured at root)…………………………………..2 Inches
Second Position (measured at root)………………..…………….3.5 Inches
Flap to Elevator mix (down elevator with first position)……..…….3/16
th
Inch
Flap to Elevator mix (down elevator with full flaps)…………….……1/4 Inch
Elevators
Full Rate…………………………………………….1.5 Inches up and down
Dual Rate……………………………………………..…1 Inch up and down
Rudders
Full Rate……………………………………………1 ¼ Inches left and right
CG…………………………...……9 and 5/8ths (measured from Front of wing)
45
To Next Page
Loading...