4. WARNING - Prevent Electrocuon. Do not connect any auxiliary components (for example cable, addional speakers,
headphones, addional audio/video components, etc.) to the system.
5. These units are not provided with an outdoor antennae; when provided, it should be installed in accordance with Arcle 810
of the U.S. Naonal Electrical Code, ANSI/NFPA 70.
6. Do not service this product yourself as opening or removing covers may expose you to dangerous voltage or other risk of
injury. Refer all servicing to qualied service personnel.
7. When the power supply connecon or power supply cord(s) are damaged; if water is entering the audio/video compartment
or any electrical equipment compartment area; if the protecve shields or barriers are showing signs of deterioraon; or if there
are signs of other potenal damage to the unit, turn o the unit and refer servicing to qualied service personnel.
8. This unit should be subjected to periodic roune maintenance (for example, once every 3 months) to make sure the unit is
operang properly.
ADDITIONAL SAFETY CONSIDERATIONS
• Install the hot tub spa to provide drainage for compartments of electrical components.
• For oor recessed spas: Install to permit access for servicing from above or below the oor. Hot tub spa equipment must be
installed below water level.
• When planning your spa installaon site, prepare for the unlikely event of rapid spa drainage.
• Do not place spa in direct sunlight while unit is empty or when sealed in shipping materials. Excessive heat build may
cause damage to spa and void warranty.
• When installing hot tub spa, allow ample space for future servicing, nong locaon of all support equipment per the model
specicaons.
SAVE THESE INSTRUCTIONS
To Next Page
Loading...
Need help?
General
