Peak Hill Industries IMMOBILIZER SHEEP WORKER User Manual (English)

Questions and Answers:

D
duncanpatriciaAug 5, 2025
What to do if pads are not clamping on Peak Hill Industries IMMOBILIZER SHEEP WORKER Farm Equipment?
- M
  marknguyenAug 5, 2025
  If the pads on your Peak Hill Industries Farm Equipment are not clamping, there are several potential causes. First, the air pressure might be set too low; try raising the pressure on the regulator. Second, there might be no power or air; ensure the battery and air are connected. Finally, there could be a problem with the air compressor itself, so check the air compressor.
A
Andrew WilliamsAug 9, 2025
How to troubleshoot no power to Peak Hill Industries Farm Equipment?
- C
  Christine WebbAug 10, 2025
  If your Peak Hill Industries Farm Equipment has no power and the LED power indicator isn't on, there are a few things you can check. First, the battery may be flat or faulty; try charging or replacing it. Second, ensure the alligator clips are on the correct terminals, matching red to red and black to black. Third, make sure the 2-pin power plug is properly inserted into the machine and tighten it if it's loose.
U
ujonesAug 14, 2025
Why is sheep clamped in wrong position in Peak Hill Industries Farm Equipment?
- A
  Aaron LopezAug 14, 2025
  If sheep are being clamped in the wrong position by your Peak Hill Industries Farm Equipment, consider these adjustments. The pressure might be too low, so try raising it. The sensor could be positioned incorrectly; slide it to the desired stop position. Also, the sides might be set too wide, allowing sheep to run too far through; adjust the width so sheep are rubbing as they walk through.
B
btaylorAug 19, 2025
What to do if sensor not triggering on Peak Hill Industries Farm Equipment?
- G
  Grant MckinneyAug 19, 2025
  If the sensor on your Peak Hill Industries Farm Equipment isn't triggering, there are several possible reasons. The battery might be low, so try charging it. The lens could be dirty, so clean it of dirt and debris. The sensor adjustment might be incorrect, so aim the sensor track into the path of oncoming sheep. Finally, a plug might be loose; check if a red light is emitting from the lens when the power is on. If not, undo the sensor cover on the panel and tighten the plug if it's loose.

Peak Hill Industries IMMOBILIZER SHEEP WORKER Specifications

General

Brand	Peak Hill Industries
Model	IMMOBILIZER SHEEP WORKER
Category	Farm Equipment
Language	English

Peak Hill Industries IMMOBILIZER SHEEP WORKER User Manual

Table of Contents

Questions and Answers:

Peak Hill Industries IMMOBILIZER SHEEP WORKER Specifications