These instructions are intended as a quick guide only. For complete instructions and
specifications, refer to DSE publication 057-300 DSEE050 Operator Manual available
from www.deepseaelectronics.com.
NOTE: Cables / wires must be installed as indicated to prevent liquid (water)
entering the device. Part number of suitable connectors / blanking plugs are given
overleaf and detailed in DSE publication 057-300 DSEE050 Operator Manual
available from www.deepseaelectronics.com.
CONFIGURATION
NOTE: DSEE050 is supplied with Factory (Default) Settings to suit most
J1939 compatible engine ECUs. Due to the configurable nature of the device this
is subject to change as required by the supplier. Contact supplier or consult the
device configuration source for full details of the configured instrumentation.
NOTE: For details of module configuration, refer to DSE Publication: 057-299
DSEE050 Configuration Suite PC Software Manual.
For configuration of the device, a PC USB to CAN Interface is required. Detailed below.
The device driver is supplied with the interface and is further available at the website
listed in the table below.
Deep Sea Electronics Ltd.
Tel: +44 (0)1723 890099
sales@deepseaelectronics.com
Web: www.deepseaelectronics.com
Deep Sea Electronics Inc.
Tel: +1 (815) 316-8706
Fax: +1 (815) 316-8708
sales@deepseaelectronics.com
Web: www.deepseaelectronics.com
To Next Page
Need help?
General
