Peak OPTIX OTV281 - User Manual

HOOK
1. Position the
wiper blade
parallel to the
wiper arm.
2. Pull the blade
into the wiper
arm hook.
3. Continue to pull pass
the front adapter tabs
until you hear the blade
lock into place. After
installation, tug firmly
on the blade to ensure
it is securely attached.
SIDE LOCK
1/4” & 3/16”
1. Lift up the
back of the
pre-attached
adapter.
2. Pull out
adapter to
remove and
discard.
1/4’’
3/16’’
3. Align the “F3”
adapter with the
corresponding
hole size on the
coupler.
4. Snap down the
“F3” adapter onto
the plastic pin in
the blade.
1/4’’
3/16’’
5. Insert wiper
arm into the
correct size hole
in wiper frame
until it locks in
place.
PINCH TAB
1. Lift up the
back of the
pre-attached
adapter.
2. Pull out
adapter to
remove and
discard.
3. Install the “M”
adapter by
aligning the arrow
on the adapter
with the arrow on
the base of the
wiper blade.
4. Snap the
adapter down in
the back to
engage onto the
base.
5. Attach the “A”
adapter onto the
“M” adapter.
6. Insert the tip
of the wiper arm
into the front of
the adapter.
7. Rotate the
blade into the
wiper arm until
the tabs in the
back of the
adapter lock into
the wiper arm.
PUSH BUTTON
(22mm)
1. Lift up the
back of the
pre-attached
adapter.
2. Pull out
adapter to
remove and
discard.
3. Install the “M”
adapter by
aligning the arrow
on the adapter
with the arrow on
the base of the
wiper blade.
4. Snap the
adapter down in
the back to
engage onto the
base.
5. Attach the “A”
adapter onto the
“M” adapter.
6. Insert the
back end of the
adapter into the
wiper arm
opening.
7. The button in
the middle of the
adapter must
lock into the
hole in the top of
the wiper arm.
To determine the size of your Push Button wiper arm, use a penny or ruler below to measure. A penny will fit firmly into the end of the 22mm wiper arm but will not fit into the end of the 19mm wiper arm.
WIPER BLADE INSTALLATION INSTRUCTIONS
Scan for PEAK
®
wiper blade product information
and installation videos or visit PEAKauto.com
WARNING: Failure to properly install wiper blades may cause the blades to not work properly or detach. Follow all instructions
carefully and use only the correct adapter for your vehicle. After installation, check to ensure the blades are securely attached.
Identify your vehicle’s wiper arm and follow the instructions. Remember to remove the plastic rubber protector before installation.
PRODUCT QUESTIONS OR COMMENTS CONTACT TECHNICAL SUPPORT:
(800) 477-5847 • owitech@owi.com

Peak OPTIX OTV281 Specifications