Why is my Peak Tool strap unsealed?
The strap might not be sealing because the wire inside or outside of the heater is broken, loose, or disconnected. In this case, check the wire or replace the heater. Another possible reason is an improper temperature setting. Finally, the tension knob value may be too high; adjust the tension knob or increase weld cooling time.
What to do if my Peak PAC Auto PAC 300 have incorrect strap feed and take-up?
If the strap feed and take-up are incorrect, consider the following potential causes and solutions: * Incorrect strap threading direction on the reel holder: Reload the strap correctly. * Incorrect loading of strap: Check if the strap is twisted in the loading section. * Strap gets in between strap coil and Reel Flange: Reload the strap. * Insufficient or excessive strap: Adjust the amount of strap accumulated. * Dust and strap residues in the Feed Unit: Check and clean the unit. * Strap end is split: Adjust the Cutter Tension Spring or change the cutter. * Loose strap at Reel Unit: Adjust or change the Brake Tension Arm Spring. * Strap jumps out of arch track: No suggested solution provided. * Poor quality of strap: Cut off the damaged part of the strap or change the ro...
Guidelines for safe operation before starting the strapping machine.
Safety precautions to follow while the strapping machine is in use.
Procedures for safe shutdown and post-operation tasks.
Safety instructions for different operational phases and equipment checks.
Warnings regarding electrical hazards, maintenance, and proper grounding procedures.
Specifications and technical details for TP-601D and TP-601L models.
Common causes and remedies for strap feed and take-up issues.
To Next Page
General