17
UNASSIGNED LOCATIONS
00D4 to 00D7 4 bytes
00DA to 00EC 19 bytes
These Unassigned Locations can be read or
written at any time. Any value written to these locations
will be lost when the DHC controller loses power, or is
reset using the PACS
®
Reset parameter. On power up, or
following a PACS
®
reset, these locations are cleared, and
therefore will always read $00, unless the user changes their
value. Using Unassigned Locations is not recommended
since future versions of the DHC Series may assign any of
these locations for specific control functions.
To Next Page
Loading...
