Peavey Invective 120 - Preset Format and MIDI Channel; Preset Data Structure; MIDI Channel Selection

17
NOTE: commands that send nibbleized preset data send HIGH byte/nibble, then LOW.
Preset Bit: 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Denition: n/a gate gate eects loop 2, 1 n/a CTL 4 master boost 1 for chan 3 1 for chan 1 Overboost
1 = active 3 2 / CTL 9 0 for chan 1 or 2 0 for chan 2 or 3 ch. 3, 2, 1
(n/a if bit 3 active)
set MIDI channel default chan=1
via sysex: F0h 00h 00h 1Bh 16h don’t care 0Dh channel - 1 F7h
(<= 0x7F) (0-15)
via footswitch:
Hold the last footswitch (9/Master Boost) for 2 seconds to enter MIDI channel select mode. e LEDs on the 1-8
footswitches will blink. You can then choose MIDI channel 1-8 by pressing one of those. You can also press 9/
Master Boost again to cancel the operation.
Note: e amp will always respond to the footswitch, but the MIDI channel allows it to
selectively respond to standard MIDI messages from other devices.
PRESET FORMAT