Peavey KOSMOS V2 - Page 7

7
Kosmos® v2
Spectrum Enhancement System
Congratulations on the purchase of your new Kosmos® v2.
The Kosmos® v2 is a second generation subharmonic and stereo image enhancement system. As the successor to the award-
winning Kosmos®, it incorporates improved circuitry and adds features to provide even more functionality for live sound and
recording applications. Like the original Kosmos®, it can provide planet rattling bass as its subharmonic processor watches the
source material, analyzes the bass, then generates additional phase-synced low frequencies an octave below it. Borrowing from
the Kosmos® Pro, the damping (tracking) has two preset ranges.
When using the Kosmos® v2, it is recommended that other equalization (especially output equalization) be set at. Adjust the
Kosmos® v2 to optimize the tone quality, then make any ne adjustments with the other gear. You may nd that little needs
to be tweaked, since the Kosmos® v2 corrects deciencies in the speaker system. Bass boost applied before the Kosmos® v2
may defeat what you are trying to accomplish by causing the sound to be muddy or distorted.
FEATURES:
• Creates intelligent, phase-synced subharmonics that don’t overpower existing material
• Dynamic source tracking yields tight, clean bass sounds
• Subharmonic activity indicator shows processing status
• A specially tuned low frequency circuit, compliments the subharmonics and can be used to fatten the low end
• High frequency image enhancement provides atmosphere through improved stereo separation and clarity
• A rear panel stereo/mono switch allows use as a channel insert or in a monophonic system
• Internal 90 Hz crossover signal can be removed from the subwoofer output when used as a side-chain effect
• Master output level controls left, right, and subwoofer output levels simultaneously
• All inputs & outputs are balanced XLR or 1/4" TRS jacks
• Signal and Peak lamps monitor signal activity and warn of overload
• Independent subwoofer output level control
Please read this guide carefully to ensure your personal safety as well as the safety of your equipment
ENGLISH
Connecting your Kosmos® II in your signal chain:
Direct: Insert Kosmos® v2 between the output of the mixer and the input of the power amp
As An Effect: Create an effects loop between your mixer and Kosmos® v2 by connecting an Aux send from
your mixer into the Kosmos® v2, and return the signal to your mixer through an aux return or channel strip
input. See MONO (15) on page 9.