Peavey xr 600c - Power Amp Section

SPECIFICATIONS
(continued)
POWER AMP SECTION
(400BH Module with DDT®)
Frequency Response:
+0, -1 dB, 10 Hz to 30 kHz @
200 watts into 4 ohms
Rated Power & Load:
210 W RMS into 4 ohms
300 W RMS into 2 ohms
Power @ Clipping:
(1% THD, 1 kHz, 120 V AC
line) Typically:
130 W RMS into 8 ohms
225 W RMS into 4 ohms
320 W RMS into 2 ohms
Intermodulation Distortion:
Less than 0.1%, 200 mW to
200 W RMS, 60 Hz & 5 kHz,
4 ohms, Typically below .05%
Total Harmonic Distortion:
Less than 0.1%, 200 mW to
200 W RMS, 20 Hz to 10 kHz,
Typically below .05%
DDT® Dynamic Range:
Greater than 26 dB
DDT® Maximum THD:
(1 kHz)
Below 0.5% THD for 6 dB
overload
Below 1% THD for 20 dB
overload
Hum & Noise:
90 dB below 200 W, 20 Hz to
20 kHz
Slew Rate:
Greater than 15 V/uSec
Damping Factor:
Greater than 100 @ 1 kHz,
4 ohms
Input Sensitivity:
1 V RMS for 200 W into
4 ohms
Input Impedance:
22 K ohms, overload protected
Power Requirements:
(Domestic)
800 W, 120 V AC, 50/60 Hz
Phantom Power:
15 V DC, Switchable