6
2015-10-15 #:180-9068-1
Programming the Remote by Searching for Codes
Manufacturer's Codes
CABLE BOX Codes
1. Turn on the device that you would like to program into your remote using the power button the
the device.
2. On the Peerless-AV Universal remote control, press and hold the button that you are trying to
program (TV, DVD, CBL, or AUX) and the OK button simultaneously for 2 seconds. The Red
LED on the remote will illuminate.
3. Press and release the CH Up button once to start the code search through the list of available
codes. Each time the CH Up button is pressed, the remote will send an Off command to the
device using the next code on the list. Each time the CH Up button is pressed, the Red LED on
the remote control will illuminate for verifi cation.
4. Continue pressing the CH up button until the device you are trying to control turns off. Then
press the Device button that you were trying to program (TV, DVD, CBL, or AUX). The Red LED
will blink two times.
5. To confi rm the code will work properly, press the Device button again. Then press the power
button. The device should turn on; However, if the device did not turn on, please repeat steps
1-4 above.
Brand Codes
ABC 107 109 113 117 131 135 144
ALLEGRO 112
ANTRONIX 045 121
ARCHER 045 121 130 132
CABLE TENNA 121
CABLE VIEW 121
CENTURY 132
COLOUR VOICE 002 003
COMTRONICS 039 110
CONTEC 114
DIRECTOR 202
GARRARD 132
GC ELECTRONICS 045
GEMINI 045 048
GENERAL INSTRUMENT 202 092 099 100 125 126 127 131 135
HAMLIN 139 142 145
HITACHI 135
HYTEX 144
JASCO 132
JERROLD 202 048 107 109 117 125 126 127 131 135
MAGNAVOX 111
MEMOREX 106
MOTOROLA 201 202
To Next Page
Loading...
Need help?
General