4
7
EN_English
Thank you for choosing a Peg-Pérego
product.
The "Z3 Adapter for car seat" are Peg
Perego accessories, compatible with the
PegPerego Z3 chassis.
They are approved for use with the car
seats of other manufacturers and for
children from birth up to a maximum
weight of 22 lbs (10 kg).
MAXI-COSI®, CYBEX, RECARO, are
registered trademarks not associated with
Peg Perego S.p.A.
No endorsement or approval has been
either expressly given or implied by these
brands.
"Z3 Adapter for car seat" for car seat:
Maxi-Cosi ®: Mico 30, Mico NXT
Cybex: Aton Q, Cloud Q
Recaro: Performance Coupe
WARNING
_ IMPORTANT: carefully
read instructions and
keep for future use.
The child’s safety could be
put at risk if the instructions
are not followed.
_
Attach the adapters onto
the chassis before attaching
the infant car seat.
_ WARNING: Check the
adapters are properly
attached onto the chassis
and the infant car seat
is properly attached to
the adapters every time
before using.
_ Do not fasten the car seat
to the chassis if the child
weighs more than 22 lbs
(10 kg).
_ WARNING: avoid serious
injury from falling or
sliding out. Always use
complete 5 point seat belt.
_ WARNING: When using
the infant car seat in the
car, check the adapters
are not attached onto the
infant car seat. Remove
the adapters from the
infant car seat before
installing it in the car.
_ WARNING:
The adapters
must always be attached
onto the chassis. Never use
the infant car seat with the
adapters attached unless it
is being used on the chassis.
_ This product is not a toy.
Do not let your child play
with this product.
_ The assembly and
preparation of the
product must be carried
out by an adult
_ Do not use this product if
there are parts missing or
signs of breakage.
NOTICE
THIS ARTICLE MEETS
OR EXCEEDS ALL
REQUIREMENTS COVERED IN
ASTM F833-15 STANDARD
Instructions for use
1 Z3 Adapter for car seat can be used
on the Z3 chassis to engage the car
To Next Page
Loading...