Peg-Perego PRIMO VIAGGIO 4-35 - Installing the Base

- 24 -
1• USING UAS SYSTEM.
If your car has “universal
lower anchors”, you can
install the child car seat
using the UAS system
instructions on page 26. The anchor
is a bar located where the seat back
meets the seat bottom (slide your
hand down between the seat back
and seat bottom to locate this bar).
Important! In addition to this manual
reading, check your vehicle manual
for child restraint use, UAS System
location or vehicle belt information.
2• USING A STANDARD LAP BELT OR
LAP/SHOULDER BELT. If your car
does not have universal lower anchors,
install the child car seat using the
instructions for lap or lap/shoulder
belt on page 29.
When using Primo Viaggio 4
.
35 with its base, first install the base, and then
install the car seat on the base.
Important! Read your vehicle manual for instructions on where to best install a child
car seat in your vehicle.
There are two ways to install the base:
Installing the Base