- 42 -
5. Push the child restraint rmly into
the vehicle seat and pull the vehicle belt
eliminating any slack. While pushing the
seat down (A), pull the lap portion of the belt
from the xed point toward the buckle (B).
Then pull the diagonal portion of the belt (C).
6. Close the locko clip following the
procedure shown in picture (D and E).
Make sure that only the lap portion of the
belt passes through the opened locko clip
on the side where the shoulder strap goes up
to the retractor (picture 6).
7. Open the locko clip on the buckle side.
Make sure that both the lap and shoulder
belts go through the locko near the buckle.
Close the locko clip following the procedure
shown in picture 6 (D and E).
Attach the TOP TETHER strap to your vehicle
following instructions at page 24.
Picture shows the correct belt pattern
when the child restraint is installed
in the forward facing mode using a
lap and shoulder belt and top tether.
Verify that the child restraint is secure. A
secure child restraint will not move more than
2.5 cm (1 inch) near the seat belt anchor.
Important Note:
The lock o clips located
on the side of the Convertible seat are used to
enhance the stability during normal use. The lock
os are not designed to replace an automatic
locking retractor or a locking latch plate.
To Next Page
Loading...
