pela tools G5018WA - User Manual

Questions and Answers

M
Michaela HillAug 9, 2025
Why does the engine get too hot on my pela tools G5018WA Saw?
- P
  Phyllis NelsonAug 9, 2025
  The engine of your Pela Tools Saw might be overheating due to several reasons. The blade could be too tight, so you should adjust the tension. Alternatively, the drive belt might be too tight, requiring you to loosen it. The teeth of the blade could be either too big or too small for the task, so consider changing the blade. If these steps don't help, the gearbox might not be adjusted correctly, and it should be inspected and adjusted. Also, check if the gearbox lacks oil and top it up if necessary. If all else fails, the engine itself might be defective and needs repair.
K
keith62Aug 14, 2025
How to prevent the blade from wearing quickly on my pela tools G5018WA?
- J
  James GilmoreAug 14, 2025
  To prevent the blade from wearing out quickly on your Pela Tools Saw, consider these points. If the teeth are too big for the piece, change to a blade with smaller teeth. Adjust the blade speed if the band saw runs too fast, and also adjust the lowering speed if it's too low. If the piece you're working with is very hard, switch to a sheet intended for the task. Ensure the blade is correctly turned and that it's not too loose by adjusting the blade tension.
M
Marisa TaylorAug 19, 2025
What to do if the blade saws obliquely with my Pela Tools Saw?
- K
  Katie DavilaAug 19, 2025
  If the blade on your Pela Tools Saw is cutting obliquely, first ensure the workpiece is clamped securely in the vice and is not skewed; fasten it correctly. Check that the blade guide is properly adjusted. The blade might not be tight enough, so adjust the blade tension. If the distance between the blade guides is too big, move them closer together. The blade could also be dull, requiring replacement. Make sure the blade speed is correct by adjusting it. Tighten the blade guides if they are loose, and adjust the blade tracking if the blade runs obliquely on the drive wheels.
S
sean07Aug 25, 2025
Why do saw teeth loosen from the blade on my pela tools G5018WA?
- G
  ginalawrenceAug 25, 2025
  Saw teeth might loosen from the blade of your Pela Tools Saw for a few reasons. The teeth could be too big for the piece or task, so you should change to a blade with smaller teeth. The lowering speed might be too high or low, requiring an adjustment. Also, ensure that the workpiece is tightly secured in the vice.
D
Deborah JenkinsAug 29, 2025
How to fix the back or sides of the blade wearing too quickly on my pela tools G5018WA Saw?
- E
  Emma RamirezAug 29, 2025
  If the back or sides of the blade on your Pela Tools Saw are wearing too quickly, it could be due to worn blade guides, which need replacement. Another cause could be that the ball bearings in the blade guides are not correctly adjusted, so adjust them. Also, check if the ball bearings in the blade guides are loose and tighten them if necessary.
R
robert97Sep 3, 2025
What to do if the blade bends on my pela tools G5018WA?
- L
  Laura WhitakerSep 3, 2025
  If the blade bends on your Pela Tools Saw, it could be because the blade is attached to the workpiece; stop the band saw and release the blade. Alternatively, the blade might be too tight, so adjust the blade tension.