22
1. Detach the battery module from its base plate;
2. Press the programming button on the battery module
for at least 10 seconds. This will restart the device, as
3. Release the button;
4. Within 5 seconds from the release, press the
programming button once; the steady LED on the up
again, the LED will turn off and the device will operate
normally);
5. Within 10 seconds hook the battery module onto the
base plate;
6. The base plate memory is written and the LED starts to
7. After 10 seconds, the module starts to operate
according to the newly programmed mode.
MOVING FROM STANDARD OPERATING MODE TO TILT-
ONLY MODE WITH BLIND SUPPLIED COMPLETELY RAISED
AND VICE-VERSA
1. Detach the battery module from its base plate;
2. Press the programming button on the battery module
for at least 10 seconds. This will restart the device, as
3. Release the button;
4. Within 5 seconds from the release, press the
programming button once; the steady LED on the up
again, the LED will turn off and the device will operate
normally);
5. Press the programming button once again; the LED on
the up arrow turns off, and the LED on the down arrow
6. Within 10 seconds hook the battery module onto the
base plate;
7. The base plate memory is written and the LED starts to
8. After 10 seconds, the module starts to operate
according to the newly programmed mode.
To Next Page
Loading...
