Grounding the Plumbing
Valve Layout
Outlet
Inlet
Drain
Water Line Connection
If pipes will be sweat soldered, do not connect
adapters to the bypass until the pipes have
cooled.
The inlet water must be connected to the inlet
port of the valve. When replacing existing water
valves, it is possible that the inlet and outlet
plumbing is installed in a reversed position.
Be certain the inlet connection on the valve is
connected to the incoming water tting from
the water supply. Do not solder pipes with lead-
based solder.
Do not use petroleum grease on gaskets when
connecting bypass plumbing. Use only 100%
silicone grease products when installing any
plastic valve. Non-silicone grease may cause
plastic components to fail over time.
NOTE:
Drain Line Connection
NOTE:
Drain Line
EQUIPMENT INSTALLATION
continued
6 • Pentair
To Next Page
Loading...
