Pentair 920 Series - Page 81

81 / 82
EN- Raychem920series-IM-H5687405/15
INDUSTRIAL HEAT TRACING SOLUTIONS
Parameter Factory User
Current Turns Ratio 1.00 to 1
Autocycle Enable
Autocycle Interval 8
Autocycle Units Hours
Override Source Remote
Load Shedding Disable
Common Setup Sub-Menu
Parameter Factory User
Temperature Units °F
Version V3.2x.xx n/a
Ext. Input Not used
Ext. Output Not used
FlashAlarmOutput Yes
Alarm Output N.C.
Language English
PointBUsed Yes
Passcode 0
Scroll Delay 0.15 secs
Copy Config… (see user manual)
Communication Setup Sub-Menu
Parameter Factory User
Protocol HTCBUS
HTCBUS Addr (factory ID)
Modbus Addr *n/a (1)
Modbus Sub Addr *n/a (0)
Baud Rate Auto
Parity *n/a (None)
Hardware None, modem, RS-232, RS-485 n/a
Driver Auto
Profile Auto
Tx Delay 0.06 secs
*n/a Parameter may only appear if certain features are enabled. Values shown in brackets are
Pentair Thermal Managament defaults if the settings are enabled.
This information defines the default 920 Series control module configuration as set by Pentair
Thermal Managament for firmware up to V3.2x. These settings are subject to change without
notice.
It is the user’s responsibility to verify that all configuration parameters are chosen appropriately
for the intended application.