Pentair Autotrol 255 Logix 740-760 - Calendar override (760 on-demand controller only); Amount of brine used per regeneration

Installer Manual 255-LOGIX 740-760 - Programming
Ref. MKT-IM-001 / C - 08.10.2019 39 / 76
6.3.7. Calendar override (760 on-demand controller only)
Set number of days for calendar override on-demand controller.
6.3.8. Amount of brine used per regeneration
Set desired brine amount. 3 salt settings are available on 740 and 760 controllers:
• S – Standard Salt – 120 grams/liter of resin;
• H – High Salt – 200 grams/liter of resin;
• L – Low Salt – 45 grams/liter of resin.
Filter Backwash Time (Filter Mode Only)
If the system is set up as a filter, the brine amount is unnecessary. The controller deactivates the brine
amount setting, and changes to an adjustable backwash time in minutes.
A Press .
→ Number of days flashes.
B Adjust displayed number with and .
→ Default time for calendar override: 0 day.
→ Days can be adjusted from ½ (.5) to 99 days.
C Press to validate the selection and advance to the next
parameter using or .
A Press .
→ Setting flashes.
B Adjust displayed settings with and .
→ Default setting is "S" standard salting.
C Press to validate the selection and advance to the next
parameter using or .
A Press .
→ Time flashes.
B Adjust displayed time with and .
→ Default time: 14 minutes.
→ The controller can be adjusted from 0 to 99 minutes for backwash.
C Press to validate the selection and advance to the next parameter using or .