Installer Manual Magnum 742-762 - Programming
54 / 106 Ref. MKT-IM-012 / C - 25.10.2019
6.3.4.5 Time of backwash
Set the time of backwash cycle (C1).
6.3.4.6 Days override (762F controller only)
Set the number of days for calendar override.
6.3.4.7 Days between regeneration (742F controller only)
Set the number of days between regeneration.
6.3.4.8 Backwash length
Set the backwash length in minutes.
A Press .
→ Backwash time flashes.
B Adjust displayed time with and .
C Press to validate the selection and advance to the next
parameter using or .
A Press .
→ Number of days flashes.
B Adjust displayed number with and .
→ Default time for days override: 0 day (disabled).
→ Days can be adjusted from ½ (.5) to 99 days.
C Press to validate the selection and advance to the next
parameter using or .
A Press .
→ Number of days flashes.
B Adjust displayed number with and .
→ Set to 0 to program as a 7-day timer.
→ Days can be adjusted from ½ (.5) to 99 days.
C Press to validate the selection and advance to the next
parameter using or .
A Press .
→ Time flashes.
B Adjust displayed time with and .
C Press to validate the selection and advance to the next
parameter using or .
To Next Page
Loading...
