Pentair AUTOTROL MAGNUM 742 - Basic Programming Parameters (3 - Cycle Filter System)

Installer Manual Magnum 742-762 - Programming
Ref. MKT-IM-012 / C - 25.10.2019 57 / 106
6.4.3. Basic programming parameters (3 - Cycle filter system)
* Default value selected with valve type and resin volume.
Parameter description Range of values
Default
value
Units of
measure
Notes
P1 Time of day
1:00 - 12:59AM
0:00 - 23:59PM
12:00 PM
Hour :
minute
Range depends on value
selected for P10.
P2 Day of week N/A None N/A -
P3
Time of
regeneration
1:00 - 12:59AM
0:00 - 23:59PM
2:00 AM
Hour :
minute
Range depends on value
selected for P10.
P4 Calendar override 0 - 99 3 Days
0 = no calendar override.
0.5 = regeneration twice a day
at time of regeneration and 12
hours later.
Calendar override skipped if at
least one day of regeneration
selected.
P5
Day of week
regeneration
N/A None N/A
Day of week regeneration is
skipped if calendar override is
more than 0 (742 controller
only).
P6 Backwash time 1 - 250 14 Minutes -
P7 Capacity of unit 1 - 900 *
m
3
Unit of measure depends on
value selected for P9.
P8 - - - -
Skipped for 3 - cycle filter
configuration.